Avocent Access Router Cyclades-PR2000 Manuel d'utilisateur télécharger pdf (Page 57)

Cyclades-PR2000

57Chapter 8 - Data-Link Protocols (Encapsulation)

STEP TWO

After configuring the general parameters, each DLC must be defined. An example will be used to demonstrate the

procedure.

A public Frame Relay network connecting offices in São Paulo, Rio de Janeiro, Salvador, and Recife is shown in Figure

11.1. Each router will have a routing table pairing destination network with router interface and gateway. A Frame

Relay Address Map is also created (either statically or dynamically) to associate each DLCI with the destination

router IP.

For the router in Salvador, the Frame Relay address map will look like this:

DLCI IP

11 200.1.1.1

21 200.1.1.4

81 200.1.1.3

Data link connections are defined in the

Add DLCI

menu, which appears at the end of the Frame Relay parameter

list. It can be reached by passing through all parameters or by using the <ESC> key at any point in the parameter

list.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 135 136

Pas de commentaire

Avocent Access Router Cyclades-PR2000 Manuel d'utilisateur Page 57