Avocent Access Router Cyclades-PR2000 Manuel d'utilisateur télécharger pdf (Page 36)

Cyclades-PR2000

36Chapter 4 - Step-by-Step Instructions

STEP ONE

The bandwidth used by CyROS for multilink circuit calculations is that given in the traffic control menu, rather

than the actual physical bandwidth available. If this bandwidth value is not set, the preset value (zero) will be

used and the multilink circuit will not function. The bandwidth for both links (SWAN 1 and SWAN 2 in the

example) should also have been set when the interface was configured. If not, the multilink circuit will not work.

Since the bandwidth was probably not set when the link was configured, you should make sure the value is the

desired one.

CONFIG=>INTERFACE=>SWAN 1=>TRAFFIC CONTROL=>GENERAL

Parameter Example Your Application

Bandwidth (bps) 64000

IP Traffic Control List None

CONFIG=>INTERFACE=>SWAN 2=>TRAFFIC CONTROL=>GENERAL

Parameter Example Your Application

Bandwidth (bps) 64000

IP Traffic Control List None

FIGURE 4.17 TRAFFIC CONTROL PARAMETERS

STEP TWO

Now, the primary link (Slot 1) and the secondary link (Slot 3) must be registered as a multilink circuit. First, a

multilink circuit is created and assigned an identifier. This is done in the CONFIG =>MULTILINK menu. Then,

the two links are added to the multilink circuit. The parameters used in the example for the two interfaces in

this multilink circuit are shown in Figures 4.18 and 4.19.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 135 136

Pas de commentaire

Avocent Access Router Cyclades-PR2000 Manuel d'utilisateur Page 36