Avocent ECMS2000U Guide de l'utilisateur télécharger pdf (Page 21)

Chapter 2: Installation 15

Figure 2.4: Networked Installation

The ECMS2000 user station has been preconfigured with factory-default network settings. If you

install only one ECMS2000 user station and one ECMS2000 transmitter on a subnet, you do not

need to change these default network settings. If you install multiple units on the same subnet, you

will need to assign a unique IP address to each unit or configure them for DHCP. This can be done

via the serial port and must be carried out before displaying multiple devices on the same network.

See Chapter 3 for more information.

NOTE: The DHCP server must be configured to assign IP addresses to the user station that do not expire. Do

not change the mode to DHCP unless the equipment is connected to a DHCP server.

Table 2.4: Figure 2.4 Descriptions

Number Description

1 Remote Workstation

2 ECMS2000 Transmitter

3 IP Network

4 ECMS2000 User

Station

5 UTP Cable

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 91 92

Pas de commentaire

Avocent ECMS2000U Guide de l'utilisateur Page 21