Avocent MERGEPOINT 53XX SP MANAGER Guide de l'utilisateur télécharger pdf (Page 23)

Installation and Setup

Configuring Power for the MergePoint SP manager

The MergePoint SP manager is supplied with single or dual AC or DC power supplies.

To configure AC power:

1. Make sure that the power switch on the MergePoint SP manager is turned off.

2. Plug the power cable into the MergePoint SP manager and into a power source.

3. Turn on the MergePoint SP manager.

To configure DC power:

DC power is connected to DC-powered MergePoint SP managers by way of three wires: Return

(RTN), Ground (GND) and -48VDC.

WARNING: It is critical that the power source supports the DC power requirements of your appliance. Make sure that

your power source is the correct type and that your DC power cables are in good condition before proceeding. Failure

to do so could result in damage to the equipment or in personal injury.

The following diagram shows the connector configuration for connecting DC power. You may

use either a flat-blade or Phillips screwdriver for this procedure.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 235 236

Pas de commentaire

Avocent MERGEPOINT 53XX SP MANAGER Guide de l'utilisateur Page 23