Avocent 1000R Manuel d'utilisateur télécharger pdf (Page 56)

50 AutoView 1000R/ AutoView 2000R Installer/User Guide

d. Select TCP/IP protocol.

e. Select Properties and note the IP address.

6. Assign the IP address in the AutoView 1000R/2000R, if needed:

a. In the HyperTerminal window, type 1 to select Network Conﬁ guration.

b. Note the AutoView 1000R/2000R IP address. The ﬁ rst three numbers

must be the same as in the server’s IP address from step 5. The last

number must be different. If the AutoView 1000R/2000R IP address is

not correct, change it as follows: type 3 to select IP address, then enter

the correct address.

c. Type Ø to exit the Network Conﬁ guration menu. If you changed the IP

address, wait per the directions on the screen.

7. From the main menu, type 2 to select Firmware Management. The current

version of your ﬁ rmware displays in the Firmware Management screen.

8. From the Firmware Management menu, type 1 to select FLASH Download.

9. Type the IP address of the TFTP server and press Enter.

10. Type the name of the FLASH ﬁ le and press Enter.

11. Conﬁ rm the TFTP download by typing y or yes and pressing Enter.

12. The AutoView 1000R/2000R will verify the ﬁ le you downloaded is valid.

Next you will be prompted to conﬁ rm the upgrade. Type y or yes and Enter.

13. The AutoView 1000R/2000R will begin the FLASH upgrade process. On-

screen indicators will display the upgrade process. When the upload is

complete, the AutoView 1000R/2000R will reset and upgrade the

internal sub-systems.

CAUTION: Do not cycle power to the AutoView 1000R/2000R during this process. A

loss of power might render the appliance inoperable and require the appliance be returned to

the factory for repair. This upgrade may take up to 10 minutes to complete.

14. Once the upgrade is complete, the startup message from step 4 will appear

on the terminal screen.

Upgrading the AVRIQ firmware

NOTE: During an OSCAR-initiated upgrade, the AVRIQ status indicator in the Main dialog box

will be yellow.

The AVRIQ modules can be upgraded individually or simultaneously.

To simultaneously upgrade multiple AVRIQs:

1. If OSCAR is not open, press Print Screen. The Main dialog box will appear.

2. Click Commands - AVRIQ Status. The AVRIQ Status dialog box appears.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 71 72

Pas de commentaire

Avocent 1000R Manuel d'utilisateur Page 56