Avocent PM 3000 Guide de l'utilisateur télécharger pdf (Page 33)

Chapter 3: Accessing the PM PDU via the Web Manager 25

• Select Static to enter the IPv6 IP address and prefix length manually.

• Select IPv6 address

unconfigured to disable IPv6.

6. Select the Ethernet Mode for the built-in interface

(ETH0).

NOTE: The MAC Address for the device will be displayed after this option.

IPv4 and IPv6 static routes

An administrator can select Network - IPv4 Static Routes or IPv6 Static Routes to configure static

routes.

To add static routes:

1. Select Network - IPv4 St

atic Routes or IPv6 Static Routes. Any existing static routes are listed

with their Destination IP/Mask, Gateway, Interface and Metric values shown.

2. Click Add.

3. Select Defaul

t to configure the default route.

-or-

Select Host IP Or Network to enter custom s

ettings for Destination IP/Mask.

Enter the required Destination IP/Mask Bits with the syntax <destination IP>/<CIDR> in the

Destinatio

n IP/Mask Bits field.

4. Enter the IP address of the gateway in the Gateway field.

5. Enter the number of hops to the destination in the M

etric field, then click Save

Hosts

An administrator can configure a table of host names, IP addresses and host aliases for the local

network.

To add a host:

1. Select Network - Hosts.

Click Add t

o add a new host.

3. Enter the IP address, hostname and alias of the host you want to add, then click Save.

o edit a host:

1. Select Network - Hosts.

Click on the IP address of the hostname you want to edit.

3. Enter a new hostname and alias, as applicable, then click Save.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 107 108

Pas de commentaire

Avocent PM 3000 Guide de l'utilisateur Page 33