Avocent SWITCHVIEW OSD - Guide de l'utilisateur télécharger pdf (Page 44)

38 SwitchView OSD Installer/User Guide

Pairing

Pairing connects two SwitchView OSD units serially, allowing access to

16 computers with one keyboard, monitor and mouse without using a

computer port. It is used in place of cascading two units. To pair your

SwitchView OSD units, use the instructions below instead of those given in

the Installation chapter.

Initial Configurations

1. Select one of your two SwitchView OSD units to be used as the slave unit.

2. Connect your VGA monitor cable to the port labeled on the back of

this unit. Next, connect your keyboard to the port labeled on the

same unit.

3. Locate the power cord that came with your SwitchView OSD unit. Plug

it into the IEC power connector on the SwitchView OSD. Make sure that

the SwitchView OSD power switch is off, then plug the other end of the

power cord into an appropriate AC wall outlet. This outlet must be near

the equipment and easily accessible to allow for unplugging prior to any

servicing of the unit.

4. Turn the SwitchView OSD unit on and press the Control key twice to

activate the On-Screen Display system. The Administrator Channel list

will appear in a pop-up menu.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 55 56

Pas de commentaire

Avocent SWITCHVIEW OSD - Guide de l'utilisateur Page 44